ELNA 7200 Service Manual page 6

TO REPLACE CIRCUIT BOARD A AND FUSE
MOUNTING
BRACKET
SETSCREW (A)
SETSCREW (D)
INSULATION
PAPER
SETSCRW (C)
SETSCREW (B)
SETSCREW (A)
SETSCREW (C)
SETSCREW (B)
SETSCREW (A)
LID
(F2) 2.5A
PART NO. 000144605
CIRCUIT BOARD A
SETSCREW (A)
SETSCREW (B)
(F1) 3.15A
PART NO. 00182904
(F2) 2.5A
PART NO. 000144605
A BOARD CASE
SETSCREW (D)
[TO REMOVE]
1 REMOVE THE FRONT COVER
(REFER TO PAGE 4).
2 REMOVE THE 4 SETSCREWS (A).
REMOVE THE CIRCUIT BOARD A TOGETHER
WITH THE MOUNTING BRACKET.
3 REMOVE THE 2 SETSCREWS (D).
4 REMOVE THE 2 SETSCREWS (B) AND 2 SET
SCREWS (C).
5 REMOVE THE CIRCUIT BOARD A AND LID.
[TO ATTACH]
REVERSE THE ABOVE PROCEDURE.
* THE SHINY SIDE OF THE INSULATION PAPER
SHOULD FACE THE CIRCUIT BOARD A.
TO REMOVE THE INSULATION PAPER,
REMOVE THE BOTH LEFT SIDE OF SET
LID
SCREWS (B) AND (D) ON THE CIRCUIT
BOARD A.
[TO CHANGE THE FUSE]
1. REMOVE THE 2 SETSCREWS (B) AND
2 SETSCREWS (C).
2. REMOVE THE CIRCUIT BOARD A AND LID.
3. PRY THE FUSE OUT WITH A SCREWDRIVER
AS SHOWN.
IF THE FUSE IS LOOSE, BEND THE FUSE
HOLDER WITH YOUR FINGERS.
REPLACE THE FUSE WITH THE SAME PART # AS
SHOWN ON THE ILLUSTRATION.
SETSCREW (C)
5
7200