Blindstitch Foot: Joining Lace To Lace - Bernina Overlocker Plus Workbook

BERNINA
Overlocker Workbook 2
Fabric: Flat edging lace, 2 pieces, 6" each
Needle: 70/10 Sharp or Microtex
Thread: 3 cones of overlocker thread
Presser Foot: Blindstitch Foot
Stitch: 3-thread rolled hem
Set the overlocker for a 3-thread rolled hem(right needle); adjust
the settings as directed below.
Attach the Blindstitch Foot.
Pull the Stitch Selection Lever toward you.
Raise the upper knife and lock it in the "up" position. You will not
cut fabric with this technique.
Move the fabric guide just to the left of the knife line on the stitch
plate.
Stiffen the lace with spray starch or fabric stiffener.
With right sides together, place the headers of the laces under
the
presser foot against the guide.
Overlock the laces together.
Gently pull the lace flat and press.
7/01/16
Blindstitch Foot: Lace to Lace
Upper Looper
Lower Looper
Left Needle
Right Needle
Stitch Length
Cutting Width
Differential Feed
Suggested Settings
Others L 460/L 450
3-5 3-5
7-9 7-8
N/A N/A
3-5 3.5
1-1.5 1-1.5
2-3 5
N 1
13