Changing The Input Source - ViewSonic Office Theater PJ820 User Manual

Changing the input source

You can select both the video and the corresponding audio signal input sources by pressing the INPUT button
on the projector or the Remote Control Unit. The input source you select appears on the screen for
approximately five seconds.
NOTE: The mode name for the currently-selected signal or the name of the signal format will be displayed
directly underneath the on-screen display of the input signal source
The on-screen display of the selected input source normally appears when projection starts, and also when the
input source is being switched. However, if the input display setting (INPUT DISP) has been turned off, this
on-screen display will not appear.
If the S-VIDEO IN and VIDEO IN connectors are both connected, the S-VIDEO input will automatically be
given priority. If you wish to view the signal being input to the VIDEO IN connector, disconnect the plug from
the S-VIDEO IN connector.
If the picture is not projected normally when an RGB signal is being input, you will need to switch the signal
mode to match the input signal.
If S-VIDEO or VIDEO has been selected as the input signal source, it may be necessary to select the correct
format which corresponds to the input signal.
ViewSonic PJ820
Projector
The video signal from the input signal source which is connected to
the S-VIDEO/VIDEO IN connector appears.
The audio from the video source needs to be connected to the
AUDIO IN (L-R) connectors for S-VIDEO/VIDEO input (page 8).
However, only one audio input is available at one time. If you wish
to change the audio input source, you will need to remove and
insert the appropriate plugs.
The signal for RGB1 will be projected. The audio output will be the
signal which is connected for RGB 1.
The signal for RGB 2 will be projected. The audio output will be the
signal connected for RGB 2.
Remote Control Unit
OR
Operation
19