Engine Oil Replacement; Air Filter - Coleman CG3500i Owner & User Manual

2）ENGINE OIL REPLACEMENT
1. Place the generator on a level surface and warm up the engine for several
minutes. Then stop the engine and turn the fuel lever to "OFF"".
2. Loosen the screw and remove the outer cover.
3. Remove the oil cap
4. Place an oil pan under the engine. Tilt the generator to drain the oil completely
5. Once oil has completely drained place the generator on a level surface.
6. Add engine oil to the upper level.
7. Install the oil filler cap
8. Install the cover and tighten the screw
 Recommended engine oil:
API Service " SJ"
CAUTION: ──────────────────────
 Be sure no foreign material enters the crankcase.
 Do not tilt the generator when adding engine oil. This could result in
overfilling and damage to the engine
Clean the oil filter every other 100hr.

───────────────────────────
3）AIR FILTER
Keeping the air filter clean is very important. Dirt induced through improperly
installed, improperly serviced, or inadequate elements will damage and wear
out the engine. Always keep the air filter element clean.
1. Remove the cover.
2. Remove the air filter cover and element.
3. Wash the element in solvent and dry.
4. Oil the element with air filter oil and squeeze out excess. The element
should be wet but not dripping.
5. Insert the element into the air filter housing.
6. Install the cover.
(see page 15,16)
13
oil filter