LOADING AND STORAGE
||
4. Hook the attaching brace's hook through the
load securing eyelet at the cargo floor from
underneath, and guide the threaded part
through the cargo grille's lower attachment
hole from underneath (1).
Slide a plastic sleeve on the threaded part of
the attaching brace - the sleeve flange
should face up - and guide it down through
the hole. Then screw on the screw cap until
its lower edge is approx. 5 mm from the grille
(2).
5. Repeat the steps in point 4 on the other
side.
6. Centre the safety grille and then tighten the
two attaching braces alternately until the
grille is properly secured.
Removal
Remove the safety grille by performing the above
steps in reverse order.
234
Note that the attaching braces can be removed
before the plastic sleeves are removed from the
holes in the grille.
Related information
•
Recommendations for loading (p. 225)
•
Load retaining eyelets (p. 227)
•
Safety net* (p. 231)
•
Cargo cover* (p. 228)
* Option/accessory.