Table of Contents
Advertisement
22
en | Installing the E2700 controller-drive tray
6
Installing the E2700 controller-drive tray
6.1
Things to know – general installation
The power supplies meet standard voltage requirements for both domestic and worldwide
operation.
Notice!
Make sure that the combined power requirements of your trays do not exceed the power
capacity of your cabinet. For power ratings on E2700 controller-drive trays and its related
drive trays, refer to the "Storage System Site Preparation Guide".
6.2
Procedure – installing the E2712 controller-drive tray
This procedure describes how to install the mounting rails into an industry standard cabinet.
You can install the controller-drive tray into an industry standard cabinet.
Warning!
Risk of bodily injury
!
Two persons are required to safely lift the component.
Warning!
Risk of bodily injury
If the bottom half of the cabinet is empty, do not install components in the top half of the
!
cabinet. If the top half of the cabinet is too heavy for the bottom half, the cabinet might fall
and cause bodily injury. Always install a component in the lowest available position in the
cabinet.
Notice!
Possible hardware damage
To prevent electrostatic discharge damage to the tray, use proper antistatic protection when
handling tray components.
To install the controller-drive tray:
1.
2015.10 | V2 | DOC
Make sure that the cabinet is in the final location. Make sure that the cabinet installation
site meets the clearance requirements.
Note: Fans pull air through the tray from front to back across the drives.
Installation manual
DSA E-Series (E2700)
Bosch Sicherheitssysteme GmbH
Hide quick links:
Advertisement
Table of Contents
