Setup Settings - Philips DVDR3300H User Manual

Setup Menu Options

Setup settings

Auto Install
Manual Search
Manual Channel Search (Page 1)
Channel/Freq.
Channel
Entry/Search 000
Program #
1
Channel Name -----
"OK to Select. NEXT to Page 2"
Press SETUP to save and exit
Manual Channel Search (Page 2)
Decoder Off
TV System
NICAM On
Fine Tuning
Press Previous for page 1 of options
Press SETUP to save and exit
60
dvdr3300h_uk_eng_17233d.indd 60 dvdr3300h_uk_eng_17233d.indd 60
(continued)
(These settings will be taken from the fi rst installation)
Press OK on the remote control to start the automatic TV channel
search process and replace all previously stored analogue TV channels.
This process may take several minutes.
In some cases, not all of the available TV channels may have been found
and stored during fi rst installation. In this case, you will need to search for
and store the missing or coded TV channels manually. Press OK to access
the submenus.
Use keys to select the options in the menu and press OK to
confi rm. Press to go back to previous menu and press SETUP
to save and exit.
{ Channel/Freq. }
{ Entry/Search }
{ Program # }
{ Channel Name }
Note: Move to { Channel Name } and press
or move to { Decoder } and press
{ Decoder }
{ TV System }
{ NICAM }
{ Fine Tuning }
– Select manual search based on channel
allocation or frequency (Programme, FREQ,
S. Channel).
Note: S. Channel (Special channel) refers to
specifi ed hyperband channels.
– Use the numeric keypad 0-9 to enter the
channel number of the TV programme or
start manual frequency search, then press OK
to confi rm.
– Use the numeric keypad 0-9 to enter the
programme number for the channel to store
(e.g., '01') and press OK to confi rm.
– Use the keys to select the channel name
and press OK to confi rm.
back to the previous page.
– If the current TV channel is transmitted by
coded TV signals that can only be viewed
properly with a decoder which is connected
to the EXT2 AUX-I/O socket, you need to
activate the connected decoder.
{ On } – Select this to allocate the connected
decoder to this TV channel.
{ Off } – Turn off the decoder feature.
– Set the TV system that produces the least
distortion of picture and sound. See last page
"TV System Guide" for more information.
– NICAM is a digital sound transmission system.
It can transmit either one stereo channel or
two separate mono channels.
{ On } – Select this to improve the sound
transmission of the TV channel.
{ Off } – Select this if the reception is poor
and the sound is distorted.
– Select this to fi ne-tune the TV channel manually
if the reception is poor. Use
the frequency and press OK to confi rm.
to go to the next page
keys to adjust
2005-10-19 10:41:31 AM 2005-10-19 10:41:31 AM