Table of Contents
Advertisement
Changing the Lock/Unlock Code
The first time the Lock/Unlock function is accessed,
the user must enter the default lock code. The
default lock code is "0000". This code can be
maintained or changed. To change the lock code,
perform the following procedure while in the "Menu
Options" List mode:
1. Use the Channel Switch to highlight "Lock
Options". Press SELECT.
2. Select "Edit Code" from the Lock Options Menu
and press SELECT.
3. Enter your current code or the default code "0000".
4. The "New Code" prompt will appear. Enter your new
four digit code using the 0-6 number buttons. You
will then be prompted to confirm the new code by
entering it again.
5. The lock code is now changed.
Note: You can use this same method to edit the
code after it has changed from the default.
Enter Code
# _ _ _ _
Streamer Lite SIR-SL1 User Guide
Audio Level
The audio of the Streamer Lite Receiver can be
adjusted to fine-tune the signal level for optimal
performance. The following setting affects both the
line output and FM output levels.
To change the audio level, perform the following
procedure while in the "Menu Options" List mode:
1. Use the Channel Switch to highlight the "Audio
Level". Press SELECT.
2. Use the Channel Switch to adjust to the desired
audio output level. A 10 segment horizontal bar
graph is displayed with a "-" sign to the left and a
"+" sign to the right. To store your setting and exit
this function, press SELECT.
Audio Level
-
Note: The volume controls on the remote control
and on the right of the unit can be used to adjust
the overall output level of the line/headphone
out.
+
21
Advertisement
Table of Contents
