General Operation; Power On/Off; Auto Shut Off; To Switch Input Mode - Sanyo LCD-15CA1Z Instruction Manual

General Operation

TV/AV button
TV /
ECO
-/- - -/- -
C.SYS
P
MENU
VIDEO S

Power ON/OFF

To Switch the TV set ON or OFF
Once you connect the AC power cord to the
AC power outlet, the TV set will be in stand-by
status and there is no picture on the screen
but the STAND-BY and POWER indicator
lights red. You can turn on the TV set by
pressing any of the following buttons:
• The POWER ON/OFF button on the remote
control.
• The "P " or "P " button on the remote
control.
• Any NUMERIC button from 0 to 9 on the
remote control.
• Any button on the control panel except MENU.
While the TV set is turned on, the STAND-BY and
POWER indicator will light green.
To Set the TV set in Stand-by Status.
While a TV program is on, press the POWER
ON/OFF button on the remote control or the
MAINS ON/OFF button on the control panel,
and the TV set will shift to stand-by status
immediately. At this time, there is no picture on
the screen. And the STAND-BY and POWER
indicator will light red.
8
8
POWER ON/OFF
button
NUMERIC
button
P P
ALTERNATE
button
S.SYS
POSITION
UP/DOWN
button
AUDIO S
NOTE:
While the TV set will not be used for a long
period of time, pull off the power plug.

Auto Shut Off

This function is available in the two conditions
below:
1) 10 minutes after no signal is input in TV mode.
2) 2 hours after the TV set is turned on by the
ON TIMER function and no operation is done.

To Switch Input Mode

By pressing the TV/AV button, you can select
one input mode from TV, AV1or AV2(DVD).

Position Selection

There are 256 (0-255) positions to select. You
can select the positions by the two operations
described below.
To Select Directly
Position 0 to 9
Select a position by pressing any of the
NUMERIC buttons.
Position 10 to 99
Press the DIGIT button and then "--" will be
displayed on the screen. Input 2 digit number
by pressing the NUMERIC buttons
sequentially.
Position 100 to 199
Press the DIGIT button twice, and then"1--"
will be displayed on the screen.Input 2 digit
number by pressing the NUMERIC buttons
sequentially.
Position 200 to 255
Press the DIGIT button twice, while "1--" is
displayed on the screen, press the DIGIT
button again and then "2--" will be displayed
on the screen. Input 2 digit number by
pressing the NUMERIC buttons sequentially.
To Make Position Up/Down.
Press P to switch to the next position.
Press P to switch to previous position.