Bootup Numlock State; Wait For 'F1' If Error; Int19 (Interrupt 19) Trap Response; Re-Try Boot - Supero X11SAE User Manual

Chapter 4: BIOS

Bootup NumLock State

Use this feature to set the Power-on state for the <Numlock> key. The
options are Off and On.

Wait For 'F1' If Error

Use this feature to force the system to wait until the 'F1' key is pressed
if an error occurs. The options are Disabled and Enabled.

INT19 (Interrupt 19) Trap Response

Interrupt 19 is the software interrupt that handles the boot disk function.
When this item is set to Immediate, the ROM BIOS of the host adaptors
will "capture" Interrupt 19 at bootup immediately and allow the drives
that are attached to these host adaptors to function as bootable disks.
If this item is set to Postponed, the ROM BIOS of the host adaptors will
not capture Interrupt 19 immediately and allow the drives attached to
these adaptors to function as bootable devices at bootup. The options
are Immediate and Postponed.

Re-try Boot

If this item is enabled, the BIOS will automatically reboot the system
from a specified boot device after its initial boot failure. The options
are Disabled, Legacy Boot, and EFI Boot.
Power Configuration

Watch Dog Function

If enabled, the Watch Dog Timer will allow the system to reset or
generate NMI based on jumper settings when it is expired for more
than 5 minutes. The options are Enabled and Disabled.

Power Button Function

This feature controls how the system shuts down when the power button
is pressed. Select 4_Seconds_Override for the user to power off the
system after pressing and holding the power button for 4 seconds or
longer. Select Instant Off to instantly power off the system as soon as
the user presses the power button. The options are 4 Seconds Override
and Instant Off.

Restore on AC Power Loss

Use this feature to set the power state after a power outage. Select
Stay-Off for the system power to remain off after a power loss. Select
Power-On for the system power to be turned on after a power loss. Select
Last State to allow the system to resume its last power state before a
power loss. The options are Stay-Off, Power On, and Last State.
4-11