Accessories; Installation Data; Boiler Dimensions - Potterton Profile 30e Installation And Servicing Instructions

Fanned balanced flue gas fired boilers
Hide thumbs Also See for Profile 30e:
Table of Contents

Advertisement

ACCESSORIES - Page 3
The following Potterton Myson controls are recommended
for use with your boiler:-
Electronic Programmer EP2001, EP3001, or EP6000
Cylinder Thermostat PTT2 or PTT1 00
Room Thermostat PRT2 or PRT1 00
Frost Thermostat PRT1 00 FR
INSTALLATION DATA - Page 3
The installation of the boiler must be in accordance with the
latest relevant requirements of the Gas Safety (Installation
and Use) Regulations, local building regulations, lEE Wiring
Regulations and the Byelaws of the Local Water
Undertaking.
Detailed recommendations are contained in the following
British Standards and Codes of Practice.
BS6798, B55440 Part 1
BOILER DIMENSIONS - Page 3
SITE REQUIREMENTS - Page 3
These boilers are not suitable for external installation and
should not be fitted directly above a cooking appliance. The
boiler may be installed in any room, although particular
attention is drawn to the requirements of the current I.E.E.
Wiring Regulations and in Scotland, the electrical provisions
of the Building Standards applicable in Scotland with
respect to the
Supplied By www.heating spares.co Tel. 0161 620 6677
Motorised Zone Valve M5V222 or M5V228
Motorised Diverter Valve M5V322
Thermostatic Radiator Valve
Data sheets describing these products are available on
request.
B55440 Part 2 B55449 Part 1
B55546 B5481 4. B56891.
BUILDING REGULATIONS.
MODEL WATER BYELAWS.
BRITISH GAS PUBLICATION DM2.
GAS SAFETY (INSTALLATION AND USE)
REGULATIONS.
BUILDING STANDARDS (SCOTLAND)
REGULATIONS.
*NOTE:
IF PIPEWORK IS TO BE RUN DOWN THE BACK OF THE BOILER
THE NORMAL CLEARANCE OF 25mm BETWEEN THE REAR OF
THE BOILER AND WALL CAN BE INCREASED TO 35mm IF
DESIRED BY INVERTING THE BOILER MOUNTING PLATE DURING
INSTALLATION
(Dimensions in brackets apply when the mounting plate is inverted).
installation of the appliance in a room containing a bath or
shower.
Where a room-sealed appliance is installed in a room
containing a bath or shower, any electrical switch or
appliance control, utilising mains electricity should be so
situated that it cannot be touched by a person using the
bath or shower.
R.c ½

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Profile 40e80e50e60e

Table of Contents