D-Link DAP1522 Configuration page 2

Manual Radio Configuration
Reset the DAP1522 Reset the DAP1522
Reset your DAP1522 to factory settings using the following procedure:
1. Switch your D-Link unit to Bridge
should always be in bridge mode at competition)
2. Plug in the power and Ethernet connections
3. Wait for the either the orange Bridge light or blue Access Point light to begin flashing
4. Hold the reset button (on the back of the unit) for 10 seconds then release
5. Wait for the light to stop flashing (this signals the wireless bridge is starting to reset)
6. Wait for the light to resume flashing, your wireless bridge is now reset
Connect the wireless bridge to your computer using an Ethernet
Connect to the Bridge Connect to the Bridge
Start Internet Explorer and type in an address of 192.168.0.50
• Username = admin
Manual Radio Configuration Last Updated: 01-06-2017
Bridge mode using the switch on the back (the wireless bridge
admin
Ethernet cable
192.168.0.50
Page 2 Page 2