Heatrae Sadia Megaflo Eco 70i Manual page 7

Outer casing
White pre-coated corrosion protected steel body shell.
Polypropylene top and base mouldings. ABS electrical
controls housings and enclosures.
Water container
Duplex stainless steel. 100% pressure tested to 1.6MPa
(16 bar)
Connections
Stainless steel grade 1.4404 (316 L)
Pipe connections accept 22mm outside diameter pipe
(compression nuts and olives supplied). Thread rate is
3/4" BSP parallel to accept standard 3/4" BSP female
fittings if required
Thermal insulation
CFC/HCFC free fire retardant expanded polyurethane
foam with zero ozine depletion potential. It has a Global
Warming Potential (GWP) of 3.1
Safety Features
Direct models: Manually re-settable thermal cut-out on
each immersion heater. Factory fitted T&P Relief Valve
Indirect models: Manually re-settable thermal cut-out on
immersion heater. Manually re-settable thermal cut-out for
primary heating - must be wired in conjunction with 2 port
motorised valve supplied. Factory fitted T&P Relief Valve
7