Other Functions; Radio Reception; Tuning To Radio Stations; Presetting Radio Stations - Philips MCD700/93 User Manual

Other Functions

Radio Reception

Tuning to radio stations

1
Press STANDBY ONy (or y on the remote)
to switch on the last selected source.
2
Press SOURCE (or TUNER on the remote)
to select TUNER mode.
3
Press BAND/9 (or TUNER on the remote)
again to select the desired band: FM or MW
(AM).
4
Press and hold the control knob to the left/right
(corresponding to
S
á on the remote until the frequency indication
starts to change, then release.
➜
The system automatically tunes to the next
strong radio station.
●
To tune to a weak station, press the control
knob to the left/right (corresponding to
) or TU +/- à / á on the remote
T
briefly and repeatedly until an optimal reception
is found.
5
Repeat Step 4 if necessary until you find the
desired radio station.

Presetting radio stations

You can preset up to 40 stations (20 in each
band) regardless of the reception.
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press the control knob upward (corresponding
to PROGRAM) or press PROG on the
remote.
➜
"PROG" icon flashes.
3
Press CH +/- (¡ / ™) or use the Numeric
Keypad (0-9) on the remote to select the
desired preset number.
➜
If "PROG" icon goes off before you select the
desired preset number, press the control knob
upward (corresponding to PROGRAM) or press
PROG on the remote.
4
Press the control knob upward (corresponding
to PROGRAM) or press PROG on the
remote again to store the radio station.
●
Repeat steps 1-4 to store other radio stations.
54
) or TU +/- à /
/
T
/
S

Listening to preset radio stations

●
In tuner mode, press the control knob to the
left/right (corresponding to
CH +/- (¡ / ™) on the remote or use the
Numeric Keypad (0-9) to select the desired
preset number.
➜
The preset number, radio frequency, and
waveband are displayed.

Setting the clock

1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜ "CLOCK SET" is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the hours.
3
Press CLOCK to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
/ ) or press
S T