Acer F7200 Series User Manual page 14

I L
TEM ABEL
16.
AUDIO OUT
17.
BNC
18.
IR receiver
19.
SERVICE
20.
RS-232
21.
12V
22.
WIRED REMOTE
AUDIO IN 3 L/R
23.
RCA (YPbPr)
AUDIO IN 4 L/R
24.
RCA (Video/ S-
Video)
25.
VIDEO
26.
S-VIDEO
27.
YPbPr
28.
AC IN
29.
Power switch
Security chain
30.
lock
31.
Kensington Lock
Note:

To use this feature, you must plug in the connector before turn on/off the projector.

Screen controllers are supplied and supported by screen manufacturers.

Do not use this jack for anything other than intended use.
Note:
If your video equipment has both S-VIDEO and RCA jacks (composite video) connect to the
S-VIDEO connector. S-VIDEO provides a better quality signal.
Warning:
As a safety precaution, disconnect all power to the projector and connecting devices before
making connections.
D
ESCRIPTION
Connect an AUDIO cable for audio loop through.
Connect a BNC cable from a computer.
Receive IR signal from remote control.
For service use.
Connects RS-232 serial port cable for remote control.
When connected to the screen through a commercially available cable,
the screen deploys automatically on start up of the projector. The screen
retracts when the projector is powered off (see notes below).
Wire remote control connector (connect with wire remote connector of
the Remote Control set).
Connect the audio cables from a audio device.
Connect the audio cables from a audio device.
Connect the composite cable from a video device.
Connect the S-video cable from a video device.
Connect a component video enabled device.
Connects the power cable.
Turns on/off the projector.
Helps protect the projector from unauthorized use.
Secures to permanent object with a Kensington Lock
system.
– 5 –
S
EE PAGE
7
13
54