Table of Contents
Advertisement
Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 Volt
Door Lock Control Circuits
These applications require the use of additional components which may include relays, fixed resistors, or for
convenience, the AS 9159 Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the
Audiovox fax back service for information on your particular vehicle for properly connecting to these types of circuits.
2 Pin Blue Connector : Programming Switch
Route the gray and black wires in the 2 pin connector from the previously installed programming switch to the control
module and plug it into the mating blue connector on the side of the module.
2 Pin White Auxiliary Output Connector : Low Current Trunk Release Output (1Blue Wire Loaded)
This wire pulses to ground via an independent RF channel from the keychain transmitter. This is a transistor-
ized, low current output and should only be used to drive an external relay coil.
WARNING: Connecting this wire to the high current switched output of trunk release circuits will damage the
control module.
Connect this wire to terminal 86 of the AS - 9256 relay (or equivalent 30A automotive relay) and wire the
remaining relay contacts to perform the selected function of this output.
3 Pin Antenna/Receiver Connector: (White Connector)
Plug the previously routed three pin connector from the antenna receiver assemble into the mating connector
of the control module. This connector supplies 12 volts, ground and RF data from the antenna receiver to the
remote start module. Be certain this connector is firmly seated making good contact to the control unit.
1. RF Programmable Features:
Feature Selection
1 Run Time
2 Ign. 2 During Crank
3 Light Output During Run Steady
4 Tach Mode
5 Voltage Level
6 Trouble Shooting
7 Door Locks
8 Crank Time
9 Gas/Diesel
To program these selectable features:
1. Turn the ignition key to the ON position.
2. Press and release the program switch 3 times.
3. Immediately turn the ignition key OFF, then back to ON.
4. Press and release the program switch 2 times
5. Use the Start button on the transmitter to advance to the feature that you want to change. EXAMPLE - If you need
to change programmable feature number 3, press and release the start button on the transmitter 3 times in
succession. The parking lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use Lock button on the transmitter to change the selection of the programmable feature. If you are not sure what
the setting for any feature is, press the lock button 1 one time, the parking lights will flash once or twice indicating
the features setting.
NOTE:
Once you enter the feature-programming mode, do not allow more that 15 seconds to pass between steps,
or the programming will be terminated.
NOTE: If the Glow Plug sense wire, Green/Yellow is connected, this wire will have priority over the setting of feature
#9.
2. Programming Tach Rate:
NOTE:
All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without
1 Flash
2 Flash
5 Min.
10 Min.
Off
On
Flash
NA
Tach
NA
NA
Off
On
1 Sec/1 Sec
3.5 Sec/3.5 Sec
0.8Sec
1.0 Sec
Gas
Diesel 10
3 Flash
15 Min.
1 Sec/Dbl 1 Sec
1.5 Sec
Diesel 15
10
4 Flash
Default
20 Min.
10 Min.
On
Steady
Tach
NA
Off
1 Sec/1 Sec
2.0 Sec
1.0
Diesel 20
Gas
128-7451
10 of 16
Hide quick links:
Advertisement
Table of Contents
