Honeywell HD31H(X) User Manual page 18

18
4. Route the cables through the cable hole and connect the
corresponding power and video (BNC) cables.
5. Secure the camera to the mounting base by pushing the camera into
base so it is held by the clips. Push the clip plate back into place and
tighten the locking screw (see Figure 1-16).
Figure 1-16 Installing the Camera and the Enclosure
6. Adjust the camera position according to the figure below to get an
optimum surveillance angle.
HD40H(X)/HD30H(X)/HD31H(X) Camera User Guide
Clip
Plate
800-18605 – Rev A – 06/2014