Part Names - Onkyo TX-NR575E Basic Manual

> Before Start > Part Names

Part Names



Front Panel
1. Í ON/STANDBY button
2. PURE AUDIO button / indicator: The display and analog video circuits are turned off to
switch the unit to Pure Audio mode and provide purer sound.
3. HYBRID STANDBY indicator: Lights if the unit enters standby mode when the features
are enabled that continue to work when this unit is in standby, such as HDMI Standby
Through and Network Standby.
4. Remote control sensor: Receives signals from the remote controller.
0 The signal range of the remote controller is within about 16´/5 m, at an angle of 20° on
the perpendicular axis and 30° to either side.
5. ZONE 2 button: Controls the multi-zone function (P29).
6. OFF button: Switches the multi-zone function off (P29).
7. DIMMER button: You can adjust the brightness of the display in three steps. It cannot be
> Install > Initial Setup
     
 
> Playback
   

turned off completely.
8. Display (P4)
9. SETUP button: You can show advanced setting items on the TV and display to provide
you with an even better experience. (*)
10.Cursor buttons ( / / /
press ENTER to confirm. Use them to tune to stations when using TUNER (P27).
11. RETURN button: Returns the display to the previous state.
12.MASTER VOLUME
13.Press the LISTENING MODE button (above) repeatedly to select a category from "Movie/
TV", "Music", "Game", then turn the LISTENING MODE dial (below) to change the mode
(P30). (*)
14.You can adjust the sound quality of the front speakers. Press the TONE button (above)
repeatedly to select the item to adjust from "Bass" and "Treble", and turn the TONE dial
(below) to adjust.

 
) and ENTER button: Select the item with the cursors and
3