Usage Instructions - Electrolux ERSB51I5MLS Instruction Manual

41 electrolux installation
After unpacking, install the bottom decoration cover onto the refrigeratory.
2. Switch-on
When switching-on, the refrigeratory enters the state of factory settings
automatically. This refrigeratory has the power-down memory function. After
the first switch-on, the refrigeratory will operate as per the settings at last
power-down.
3. Put foods into refrigeratory.
After electrifying and operation for a period of time (about 3-5 hours in
summer), the inner side of the refrigeratory is fully cool. Then, foods can be
put in and the refrigeratory can be used formally.
Tips: after the temperature setting has been changed or new food has been
put in, the inner temperature of the refrigeratory can reach a balance after a
period of time. And the length of the period is determined by the changing of
temperature setting, ambient temperature, opening frequency, amount of food
in the refrigeratory, etc.
Refrigerator
Though most places in the refrigerator can
be kept at 2-8°C averagely by adjusting
temperature setting, the food in the
refrigerator cannot keep fresh for a long
time. Therefore, the refrigerator can only
serve to store food in short term.
Adjustment of shelf
According to the need of the food to be
stored, the shelf can be adjusted to a proper
height. To ease the use or adjustment of the
shelf, it is designed for sliding; when
cleaning the glass shelf, please pull the
glass shelf in the direction 1 and whirl it in
the direction 2 at the same time until it is
perpendicular to the original position, and
then take it out at 90° in the direction 3.
Adjustment and cleaning of door
tray
Hold two sides of the tray, lift it up in the ①
direction, and pull it out in the direction ②.
After cleaning, install the tray in opposite
directions. The installation place can be
adjusted according to the height of the food.
1
2
3
1
2

Usage instructions

Operation and precautions for ice maker (only some models)
The water pipe cannot be used where environmental temperature is under 0°C
or it may lead to freezing.
The water pipe cannot be connected to hot water, which may lead to
deformation.
The water pipe should be used in the pressure range 30-100psi.
Lower pressure may cause smaller ice pieces and longer water exiting time.
But higher pressure may damage the filter.
The pipe cannot be connected to drinks, alcohol or other liquids except for
water.
Connection of water pipes: please contact the after-sales Service Department
of the Company or professionals to install to avoid any risk.
Attention
The water pipes must be connected under the condition of power-off. Electric
shock may cause serious injury or death.
1. Turn off the water-tap.
2. Connect water pipe onto the water-
tap. The water pipe should be long
enough to prevent the drop-off of
the water pipe caused by removing
of refrigeratory.
3. Turn off the refrigeratory.
4. Use a connecting pipe to connect
the water pipes behind the
refrigeratory and on the water-tap.
5. To prevent the drop-off or leaking of
the water pipes, they must be fixed
by fixed pins.
6. Turn on the water tap to check
leakage.
7. The refrigeratory is energized an
used normally.
usage instructions electrolux 42
Ice maker