Step 9 Optional: Extending The Power Cable - Samsung AC100KXADEH Installation Manual

Installation Procedure
Step 9 Optional: Extending the power
cable
1 Prepare the following tools.
Tools
Crimping pliers
Connection sleeve
(mm)
Insulation tape
Contraction tube
(mm)
2 As shown in the figure, peel off the shields from the
rubber and wire of the power cable.
∙ Peel off 20 mm of cable shields from the pre-
installed tube.
CAUTION
∙ For information about the power cable specifications
for indoor and outdoor units, refer to the installation
manual.
∙ After peeling off cable wires from the pre-installed
tube, insert a contraction tube.
Power cable
Pre-installed tube for the power cable
20
3 Insert both sides of core wire of the power cable into
the connection sleeve.
∙ Method 1: Push the core wire into the sleeve from
both sides.
∙ Method 2: Twist the wire cores together and push it
into the sleeve.
Method 1
Connection sleeve
16
English
Spec Shape
MH-14
20 x Ø6.5
(HxOD)
Width 19
mm
70 x Ø8.0
(LxOD)
20 60
20 120
180
(Unit: mm)
Method 2
Connection sleeve
4 Using a crimping tool, compress the two points and flip it
over and compress another two points in the same location.
∙ The compression dimension should be 8.0.
∙ After compressing it, pull both sides of the wire to
make sure it is firmly pressed.
Method 1
Compress it 4 times.
5 mm
5 Wrap it with the insulation tape twice or more and
position your contraction tube in the middle of the
insulation tape.
Three or more layers of insulation are required.
Method 1
Insulation tape
20
40 mm
6 Apply heat to the contraction tube to contract it.
7 After tube contraction work is completed, wrap it with
the insulation tape to finish.
Compression
dimension
Method 2
Compress it 4 times.
5 mm
Method 2
Insulation tape
35 mm
Contraction tube
Insulation tube