Safety And Regulatory Compliance - Alcatel-Lucent OAW-AP228 Installation Manual

Safety and Regulatory Compliance

Alcatel-Lucent provides a multi-language document that contains country-specific restrictions and
additional safety and regulatory information for all Alcatel-Lucent access points. This document can
be viewed or downloaded from the following location:
Regulatory Model Name
The regulatory model name of OAW-AP228 is APIN0228.
FCC
This device is electronically labeled. To view the FCC ID:
1. Log into the controller WebUI
2. Navigate to Maintenance > Controller > About.
Alcatel-Lucent access points must be installed by a professional installer. The professional installer is
!
responsible for ensuring that grounding is available and it meets applicable local and national electrical codes.
CAUTION
RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits. This
equipment should be installed and operated with a minimum distance of 9.84 inches (25 cm) between the
!
radiator and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating
CAUTION
in conjunction with any other antenna or transmitter.
RF Radiation Exposure Statement: When operated in the 5.15 to 5.25 GHz frequency range, this device is
!
restricted to indoor use to reduce the potential for harmful interference with co-channel Mobile Satellite
Systems.
CAUTION
FCC Class B Part 15
This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation
is subject to the following two conditions:
This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause

undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
!
void the user's authority to operate this equipment.
CAUTION
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the manufacturer's instructions,
may cause interference harmful to radio communications.
If this equipment does cause interference, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

12
www.alcatel-lucent.com/enterprise
OAW-AP228 Wireless Access Point
| Installation Guide