Precautions - Icom IC-F29SR2 User Manual

PRECAUTIONS

R DANGER! NEVER short the terminals of the battery
pack. Shorting may occur if the terminals touch metal
objects such as a key, so be careful when placing the
battery packs (or the transceiver) in bags, and so on. Carry
them so that shorting cannot occur with metal objects.
Shorting may damage not only the battery pack, but also the
transceiver.
R DANGER! NEVER use and charge Icom battery packs
with non-Icom transceivers or non-Icom chargers. Only Icom
battery packs are tested and approved for use with Icom
transceivers or charged with Icom chargers. Using third-
party or counterfeit battery packs or chargers may cause
smoke, fire, or cause the battery to burst.
R WARNING! NEVER hold the transceiver so that the
antenna is very close to, or touching exposed parts of the
body, especially the face or eyes, while transmitting. The
transceiver will perform best if the microphone is 5 to 10 cm
away from the lips and the transceiver is vertical.
R WARNING! NEVER operate the transceiver with a
headset or other audio accessories at high volume levels.
If you experience a ringing in your ears, reduce the volume
level or discontinue use.
R WARNING! NEVER operate the transceiver while driving
a vehicle. Safe driving requires your full attention—anything
less may result in an accident.
3
CAUTION: DO NOT operate the transceiver unless the
flexible antenna, battery pack and jack cover are securely
attached. Confirm that the antenna and battery pack are dry
before attaching. Exposing the inside of the transceiver to
dust or water can cause serious damage to the transceiver.
CAUTION: DO NOT place or leave the transceiver in direct
sunlight or in places with temperatures below –25°C or
above +55°C.
CAUTION: DO NOT modify the transceiver. The
specifications may change and then the transceiver may not
comply with the requirements of required regulations. The
transceiver warranty does not cover any problems caused
by unauthorized modification.
CAUTION: DO NOT use harsh solvents such as Benzine
or alcohol when cleaning, because they will damage the
transceiver surfaces.
DO NOT operate the transceiver near unshielded electrical
blasting caps or in an explosive atmosphere.
DO NOT push [PTT] when you do not actually intend to
transmit.