Video Setup - Philips DVP1033 User Manual

[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
[LT/RT] - For the surround sound output
through two speakers.
[Stereo] - For the stereo output.
[Digital Audio]
receiver that is connected through the digital jack
(coaxial/digital).
[Digital Output] - Select a type of digital
output.
[All] - Support multi-channel audio
formats.
[Off] - Disable digital output.
[PCM Only] - Downmix to two-channel
audio format.
[LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling rate.
- For discs recorded at sampling
rate of 48 kHz.
- For discs recorded at sampling
rate of 96 kHz.
Note
[LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only].
The higher the sampling rate, the better the sound
quality.
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press to set the volume.
3. Press OK
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
[3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
[Movie Mode] - Select a sound effect for
movies.
[Music Mode] - Select a sound effect for
music.
[CD Upsampling]
For better sound quality in stereo mode, convert
the music CD to a higher sampling rate.
[Off] - Turn off CD-upsampling.
- Convert to twice the original
sampling rate.
- Convert to four times the original
sampling rate.
[Night Mode]
Make loud sound level softer and soft sound level
louder so that you can watch the DVD movies at a
low volume, without disturbing others.
[On] - Enjoy quiet viewing at night.
[Off] - Enjoy surround sound with a full
dynamic range.
Note
Applicable only to Dolby Digital encoded DVDs.

Video setup

Press SETUP.
»
2
Press to select [Video Setup], and then
press to enter the submenu.
3
Select an option, and then press OK.
Select a setting, and then press OK.
To return to the previous menu, press
BACK.
To exit the menu, press SETUP.
[TV System]
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TVs in your country.
[PAL] - For a PAL-system TV.
[Multi] - For TV that is compatible with both
PAL and NTSC.
[NTSC] - For an NTSC-system TV.
[TV Display]
Select a display format:
menu is displayed.
EN 13