Samsung SH18BW6 Service Manual page 23

Disassembly and Reassembly
No Parts
4 Heat Exchanger
5 Fan Motor
&
Cross Fan
4-4
Procedure
1) Loosen 2 fixing earth screws(CCW) of right
side. (Use +Screw Driver.)
2) Detach the Connection Pipe.
3) Detach the Holder Pipe at the rear side.
4) Loosen the 4 fixing screws(CCW) of right and
left side. (Use +Screw Driver.)
5) Lifting the Heat Exchanger up a little to push
the up side for separation from the indoor
unit.
First, check Comp. Down and then disconnect
the connection pipes before you disassemble
the Evaporator from indoor unit.
1) Loosen the fixing screw(CCW).
(Use +Screw Driver.)
2) Detach the Fan Motor from the Fan.
3) Detach the Fan From the left Holder Bearing.
Remark
Samsung Electronics