Speaker Settings 49 - Philips DVDQ50 Owner's Manual

Allows you to select speaker settings, volume balance and
delay time and to test the speaker settings.
Speaker settings are only active on the Analog Multi-Channel
Output.
1
Press SYSTEM MENU.
2
Press 9 repeatedly to select
3
Press 9 repeatedly to select Speakers, then press :.
Z Y
1en 1en 1
s
Front L & R
Center
Surround L
Surround R
Sub Woofer
OK to exit 0dB L 0dB
4
Press 8 or 9 to select the speaker you want to adjust.
Select Front L & R (left and right), Center, Surround L (left),
Surround R (right), or Sub Woofer. Your audio system may refer to
the Surround speakers as the rear speakers.
5
After selecting the speaker, press :. Then, press 8 or 9 to
adjust the sound of the speaker.
Press OK to go back and select another speaker. Repeat
steps 4-5 as often as necessary until you are satisfied with
the speaker settings.
6
Press SYSTEM MENU to remove the menus.
will be selected.
G
, then press :.
d
st
Speakers

Speaker Settings 49

Helpful Hint
• The Dolby Digital licensing
agreement does not prohibit
any particular speaker settings.
Instead, it gives guidelines for
possible speaker settings.
1,6
2-5