Direct Wireless Connection - Yamaha DISKLAVIER ENSPIRE ST/PRO Owner's Manual

4
Press the POWER
Connection between the Disklavier and the wireless router (access
point) is automatically established in approximately 15 to 20
seconds.
5
Open the Wi-Fi setting screen on your smart device.
6
Enable the Wi-Fi function.
7
From the network list shown on the screen, tap on the
network to which you connected your Disklavier.
If necessary, enter a password, and then connect.

Direct Wireless Connection

You can use the Disklavier as an access point to establish a direct wireless
connection between the Disklavier and your smart device.
1
Press the POWER
2
Connect the USB wireless LAN adaptor (UD-WL01) to the
USB port on the rear of the switch box.
LED lamp
WPS button
3
Set the WLAN switch on the rear of the switch box to "AP."
button to turn the power on.
button to turn the power off.
WLAN switch
Getting Started
Note:
For details on the Wi-Fi setting,
refer to the owner's manual supplied
with your smart device.
Note:
If the Disklavier is connected
directly to your smart device, no
Internet access is available on your
smart device.
Note:
As a default, the WLAN switch is
set to the "RT" position.
Chapter
2
18