Connecting The Power Supply; Infra Red Remote Control - Philips DVD955 Instructions For Use Manual

Connecting the power supply

1
Plug the female end of the power cable supplied into the Power connector
on the rear of the player.
2
Plug the male end of the cord into an AC outlet.
Note: The player automatically adjusts to the local mains voltage.
When the player is in the "STANDBY/OFF" position, it is still consuming some
power. If you wish to disconnect your player completely from the mains, withdraw
the plug from the AC Outlet.
Caution: Only qualified service personnel should remove the
cover or attempt to service this device.

Infra red remote control

Loading the batteries
1
Open the battery compartment cover.
2
Insert two 'AA' (LR-6) batteries as indicated inside the battery
compartment.
3
Close the cover.
Caution: Do not mix old and new batteries. And never mix
different types of batteries (standard, alkaline, etc.)
PREPARATION 17