Siemens SIMATIC IPC647D Operating Instructions Manual page 27

Procedure for IPC847D
1. Disconnect the device from the supply system.
2. Attach the holder
3. Re-install the module bracket
4. Install the RAID adapter card in the following slot:
5. Secure the RAID adapter card with the holder.
6. Insert the capacitor block cable con-
7. Insert the adapter cable at the marked
8. Connect the adapter cable to the required drives.
For removal, follow the steps in reverse order.
SIMATIC IPC647D/847D Hardware RAID Configuration
Compact Operating Instructions, 08/2014, A5E34655907-AA
①
for the capacitor
block to the module bracket
②
screw .
Press the capacitor block
holder, and secure the capacitor block
⑤
with a cable tie .
device.
• Bus board variant 1 with 7 PCI slots: Slot 7
Notes:
– Slot 6 must be free and is sealed with the supplied perforated slot bracket to
ensure cooling.
– Slot 8 may contain an expansion card with a maximum power consumption of
10 W.
• Bus board variant 2 with 8 PCI slots: Slot 6
Notes:
– Slot 5 must be free and is sealed with the supplied perforated slot bracket to
ensure cooling.
nector at the marked position.
position.
Make sure that the connector latch
engages.
5.1 Removing and installing the Hardware RAID adapter card
③
with two
④
into the
③
in the
Maintaining and repairing the device
27