IOGear GUWAVKIT4 User Manual page 19

3. Adjusting audio settings
A. Configuring audio ports
You can playback audio either through the Receiver Base' audio port or the PC's audio
port. However, you cannot use the audio ports on the Receiver Base and on the PC at
the same time.
By default, the audio ports on the GUWAVKIT4 are automatically enabled each time you
connect. When you disconnect the GUWAVKIT4 from the PC, the audio ports on the PC
are automatically re-enabled. To change the default settings, you may need to manually
adjust the audio settings in Windows®, as described in this section. For example, if you
want to use the PC's audio ports while the PC is docked, you will need to change the
default settings.
To change the default settings, you may need to manually adjust the audio settings in
Windows®, as described in this section. For example, if you want to use the PC's audio
ports while the PC is docked, you will need to change the default settings
B. Setting Audio Output Device
The PC audio output device should set itself automatically to the GUWAVKIT4's
connected wireless audio device when the wireless connection is made to the Receiver
Base. If it does not switch automatically, it can be selected manually as follows:
In Windows XP:
• Right click the Volume icon in the System Tray and select Adjust Volume Properties.
• In the Sounds and Audio Devices Properties screen, select the Audio tab.
• In the Sound Playback > Default Device drop-down box, select the USB PnP
Sound Device.
• Click OK to save the new setting.
19