Introduction - Stanley brandon dhw Installation And Commissioning Manual

Congratulations on purchasing this fine Irish made Oil-fired Cooker. It is built to exacting standards and it will
give you every satisfaction in use. We invite you to read carefully the operating and installation instructions
provided. This will enable you to familiarise yourself with this appliance.
This appliance is hot while in operation and retains its heat for a long period of time after use.
Children, aged or infirm persons should be supervised at all times and should not be allowed to touch
the hot working surfaces while in use or until the appliance has thoroughly cooled.
To ensure safety, satisfaction and reliable operation, this quality cooker should be installed by a trained and
competent person.
Please note for DHW Models the domestic hot water facility involved must fully conform to good plumbing prac-
tices, established standards, Regulations and OFTEC Recommendations.
The complete installation must be done in accordance with current Standards and Local Codes. It should be
noted that the requirements and these publications may be superseded during the life of this manual.
As manufacturers and suppliers of cooking and heating appliances, we take every possible care to ensure,
as reasonably practicable, that these appliances are so designed and constructed as to meet the general
safety requirements when properly used and installed.
* Section 10 of the Consumer Protection Act 1987.
* Safety, Health and Welfare at Work Act.
IMPORTANT NOTICE: Any alteration to this appliance that is not approved in writing by Waterford Stanley will
render the guarantee void.
IMPORTANT — Control of Substances Harmful to Health:
It is the Users/Installers responsibility to ensure that the necessary personal protective clothing is worn when
handling materials that could be interpreted as being injurious to health and safety.
When handling Firebricks, Fire Cement or Fuels, use disposable gloves.
Exercise caution and use disposable masks and gloves when handling glues and sealants.
When working with fibre glass, mineral wool, insulation materials, ceramic blanket/board or kerosene fuel oil,
avoid inhalation as it may be harmful. Avoid contact with skin, eyes, nose and throat. Use disposable protec-
tion. Installation should be carried out in a well ventilated area.
This installation must comply with the following:
The Building Regulations: Part J England & Wales, Part F Section 4 Scotland, Part L Northern Ireland and Part
J Ireland.
B.S. 7671: Requirements for Electrical Regulations.
Safety Document 635: The Electricity at Work Regulations.
B.S. 5410: Oil Installations Part 1 under 45 kW.
The Control of Pollution (Oil) Regulations Health & Safety at Work Act.
FOR DHW MODELS ADDITIONALLY THE INSTALLATION MUST COMPLY WITH THE FOLLOWING:
B.S. 7593: Treatment of Water in Domestic Hot Water Systems.
B.S. 7074: Parts 1 & 2: Hot Water Supply.
The manufacturers reserve the right to make alterations to design, materials or construction for manufacturing or other reasons subsequent to publica-
tion.

Introduction

2