Connecting To Optional Equipment; Inserting Batteries Into The Remote Control - Philips DVD 620 Owner's Manual

Preparation
Connecting to Optional
Equipment
G A digital component with a built-in MPEG 2 or
Dolby Digital™ decoder allows you to enjoy the
surround sound while producing the effect of
being in a movie theater or a concert hall.
G The player outputs the surround sound signals
from the DIGITAL OUT COAXIAL connectors.
If your receiver has a MPEG 2 or Dolby
Digital™ decoder,
1
Connect the COAXIAL DIGITAL AUDIO OUT
of the DVD player to the COAXIAL DIGITAL
AUDIO IN on your receiver.
2
You will need to set the DVD player's digital
output to ALL (see 'Personal Preferences').
REAR
SPEAKERS
RECEIVER with
MPEG 2 or Dolby
Digital™ decoder
TO SCART IN
TO COAXIAL IN
DIGITAL AUDIO OUT
PCM-MPEG2-Dolby Digital
COAXIAL
Notes:
– If the audio format of the digital output does
not match the capabilities of your receiver, the
receiver will produce a strong, distorted sound or
no sound at all.
– To see the selected audio format of the
current DVD in the Status Window, press SYSTEM
MENU.
REAR
SPEAKERS
OR
TO VIDEO IN
(CVBS)
R L
TV OUT
AUDIO OUT VIDEO OUT
Inserting batteries into the
Remote Control
1
Open the battery cover.
2
Insert batteries (AA size) with the correct
polarity as indicated by the + and - symbols
inside the battery compartment.
3
Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly
and kept away from children.
Using the Remote Control
G Direct the remote control at the remote sensor
of the DVD player.
G Do not drop the remote control.
G Do not leave the remote control near extremely
hot or humid place.
G Do not spill water or put anything wet on the
remote control.
- +
+ -
10