Audiovox PROV916 P Installation Manual page 8

Audiovox installation guide tv/monitor with dvd prov916/prov916 s/prov916
Hide thumbs Also See for PROV916 P:
Table of Contents

Advertisement

VOD916/PROV916/PROV916 S/PROV916 P
To Secondary AV Monitor
12 VDC Power and Ground
Auxillary
video display
1) Make the connections to the vehicle for the 12 pin wiring harness and battery wire.
2) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on
the main PCB and into the Mini-Din Connector on the main PCB.
3) Pull the wire tie loop tight and cut off the excess.
4) Connect the 12 pin harness to the mating connector on the Video Monitor.
5) Connect the wired headphone to the remote headphone jacks to the video monitor if those options are
being included.
6) Connect the 14 Pin wire to the FM modulator.
7) Connect power harness to vehicle's electrical system by tapping into an accessory hot line.
8) Verify all functions of the System before final mounting of the finished assembly.
9) Mount and connect the Television antenna.
Note: A VCP or other A/V Component can be connected to the video monitor system using a second
source component harness (purchased separately, part number: 8010730). This harness would plug
into the Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1= VCP or VCP with TV Tuner (Mini-Din on main PCB)
2= AUX-IN (VCP, Game or future DVD etc...)
3= Built-in DVD
Hard Wired FM Modulator Output
Satalite
Radio
TO
Am/Fm
FACTORY
Antenna
RADIO
Dash Radio
CHOKE
RCA-Female
INPUT
VIDEO
LINE
OUT
Patch Cord
VIDEO
RCA Male to Male
(Yellow)
Optional Remote Headphone Stations
Green
(Right+)
Black
(Ground)
Gray
(Left+)
12 VDC Power and Ground
FM
14Pin FMM Cable
Modulator
Item #8
Second IR
Input
Battery 12V
Power Harness
Item #3
TO
OPTIONAL
Line Out-L (White)
ADDITIONAL
MONITOR
Line Out-R (Red)
Line Out-V (Yellow)
Stereo
Headphone Jack
Stereo
Headphone Jack
Dome Light
Power Source
Power Connector
"Y" Adapter
4 Pin
for use with
Non-Stereo
Clean the IR Receiver Window on the front of the VCP.
Installations
Remove Adhesive Backing and Apply IR LED to IR
Item# 5
Figure A
-6-
Power Harness
Item #3
Accessory
Harness - Optional
(P/N:8010730)
Red RCA (Audio Right)
White RCA (Audio Left)
Yellow RCA (Video)
TV
ANTENNA
OPTIONAL

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prov916 sVod916

Table of Contents