Kenwood KRC-225 Service Manual page 8

KRC-225/235/265/265S
Set the controls and switches as follows.
BALANCE : center position
FADER : center position
No. ITEM
CASSETTE DECK SECTION
HEAD
[1]
HEIGHT
HEAD
[2]
AZIMUTH
B
A
B
A
8
ADJUSTMENT
BASS : center position
TREBLE : center position
OUTPUT RECIEVER
TAPE
SETTINGS SETTINGS
SCC-1659 - TAPE PLAY
Connect an AC
TCC-153 voltmeter and
TAPE PLAY
10kHz oscilloscope to
SP outputs.
(2-LINE TAPE)
(FWD)
(RVS)
LOUDNESS : OFF
ALIGNMENT
POINTS
1) During FWD transport adjust
line A of 2-LINE TAPE passes through the center
of the head shield plate (core center area)
2) During RVS transport adjust
line B of 2-LINE TAPE passes through the center
Head Height
of the head shield plate (core center area)
Screw
3) After the alignment above, reverse the transport
direction and check the FWD alignment again. If it
is deviated, perform alignment again. (Tape used :
SCC-1659, manufactured by A-BEX)
Adjust the azimuth for each L ch/R ch or FWD/RVS
Head Azimuth
becomes maximum.
Screw
TAPE SPEED
HEIGHT
(FWD)
HEIGHT/AZIMUTH
(FWD)
ALIGN FOR
and ' so that
F F
and ' so that
R R
' '
HEIGHT
F R
(RVS)
HEIGHT/AZIMUTH
F R
(RVS)