Electrolux WEK 7 Service Manual page 10

6.1.3 Inspecting the light switch

1. Switch the inside lighting of the door opening on (see No. 5 in the Operating Functions)

2. The operating display shows "OFF"

3. Close the door- the inside lighting should go off. Refer to 4 and 5 if the light does not go

off.

4. Remove the operation (see 6.2.1) and then check the sensor.

The sensor should be clearly bent as shown in the

photo. If necessary, bend it carefully of replace the

board.

5. Check the position of the door magnet if the inside lighting still does not go off, i.e. turn the

magnet in the magnet housing.

6.1.4 Replacing the door seal

1. Removal

Left the seal at the corner and pull it off

2. Fitting

Carefully press the seal in at the corners and travel

along the seal with the fingers

168 650

Table of Contents

Show Quick Links