Note On Startup Screen (Menu Language Select Screen) - NEC NP3150 User Manual

Note on Startup screen (Menu Language Select screen)

W
To select a menu language, follow these steps:
1. Use the SELECT
guages for the menu.
2. Press the ENTER button to execute the selection.
E
NOTE:
• The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is blinking green.
• If you turn on the projector immediately after the lamp is turned off or when the ambient temperature is high, the cooling fans
will run for a moment and then you will get an image on the screen.
• Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp lighting
is stabilized.
W
W
NOTE: Turning the Main Power Switch Off then Back On
Allow a minimum of one second between turning off the main power switch and turning it back on again.
The same will be applied when a power strip equipped with a switch and a breaker is used.
Failing to do so could result in no power to the projector. (There will be no stand-by LED)
Should this happen, unplug the power cable and plug it in again. Turn on the main power switch.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
button to select one of the 21 lan-
E
3. Projecting an Image (Basic Operation)
SELECT
3D REFORM
SELECT
3D REFORM
24
POWER POWER
OFF ON
COMPUTER
1
2
VIEWER
VIDEO
COMPONENT
3
S-VIDEO NETWORK
AUTO ADJUST SOURCE
SELECT
POWER POWER
OFF ON
COMPUTER
1
2
VIEWER
VIDEO
COMPONENT
3
S-VIDEO NETWORK
SELECT
AUTO ADJUST SOURCE