Measurement And Adjustments; Adjustment Procedure Flowchart; Cautions For Adjustment; Setting Before Adjustment - Panasonic PT-P1SDU Service Manual

7 Measurement and Adjustments

7.1.

Adjustment Procedure Flowchart

7.2.

Cautions for Adjustment

· Never unplug the power cord until the power indicator on the projector illuminates red.
· To maintain and ensure safety, always use the designated components for replacement parts.
· If removing any clamps, lead wires or connectors, always place them back in their proper locations.
· Be careful not to damage the lead wires or components when using a soldering iron or similar tool.
7.3.

Setting Before Adjustment

· Set up the projector to obtain the projection distance below.
· Turn the zoom ring of the projector to obtain the largest size of the picture.
7.4.

Convergence Adjustment

Execute this adjustment when replacing the LCD panel (B).
7.4.1. Tools to be used
Service Kit (Part No. TZSH07003): This kit is composed of 3 extension flexible cables and 2 connector extension cables.
Note:
· Consult your dealer or Authorized Service Center for the service kit.
7.4.2. Preparation
1. Loosen 2 screws fixing the panel adjuster and 2 screws fixing the panel attachment, then tighten the 4 screws temporarily just
until the LCD panel can be shifted by your fingers.
19
PT-P1SDU / PT-P1SDE / PT-P1SDEA