Introduction; About This Guide; System Compatibility; Getting Started - Emerson 0037-7303A Installation And Operation Manual

1

Introduction

1.1. About this Guide

This manual describes how to install and configure
the Commercial Communicating Programmable
Thermostat (P/N 810-1500).

1.2. System Compatibility

This Commercial Communicating Programmable
Thermostat replaces thermostats for the following
types of system:
• Standard Heat & Cool Systems
• Two Stage Heat & Two Stage Cool Systems
• Air Source Heat Pump (with Aux. or Emergency
Heat)
• Ground Source Heat Pump (with Aux. or Emergen-
cy Heat)
• Air or Ground Source Heat Pump (No Aux. or
Emergency Heat)
• Standard Heat Only Systems
• Standard Central Air Conditioning
• Gas or Oil Heat
• Electric Furnace
• All Systems Listed Above with Economizer Control
CAUTION! Failure to read and follow all in-
structions carefully before installing or operat-
ing this control could cause personal injury
and/or property damage.
To prevent electrical shock and/or equipment dam-
age, disconnect electric power to system at main fuse or
circuit breaker box until installation is complete.
This product does not contain mercury. However,
this product may replace a unit which contains mercu-
ry. Do not open mercury cells. If a cell becomes dam-
aged, do not touch any spilled mercury. Wearing non-
absorbent gloves, clean up the spilled mercury and
place into a container that can be sealed.
For proper disposal refer to www.white-rodgers.com
for a location to send the product containing mercury.
Do not use on circuits exceeding specified voltage.
Higher voltage will damage control and could cause
shock or fire hazard.
About this Guide
2

Getting Started

2.1. Pre-Installation
Checklist
Before you begin to install your Commercial
Communicating Programmable Thermostat:
• Read these instructions thoroughly.
• Check the package from your thermostat to make
sure you have all of the required parts (see Section

2.2., Required Items).

• Assemble the required tools (see Section 2.3., Re-
quired Tools).
2.2. Required Items
• Thermostat (1)
• Wall anchors (2)
• Mounting screws (2)

2.3. Required Tools

• Flat blade screwdrivers – 1 large and 1 small
• Hand or power drill with 3/16 inch drill bit
• Wire strippers
• Level (optional)
Introduction • 1