Specific Safety Rules; Assembly And Adjustment - Black & Decker KTC12 User Manual

Do not probe the charger.
•
Labels on the charger
The following symbols are found on your charger:
Your charging base is double insulated; therefore no
earth wire is required. Always check that the power
supply corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.

Specific Safety Rules

Hold tool by insulated gripping surfaces when
•
performing an operation where the tool may
contact hidden wiring or its own cord. Contact
with a "live" wire will also make exposed metal parts
of the tool "live" and shock the operator.
When working on a ladder or on scaffolding be
•
sure to lay the tool down on its side when not in
use. Some tools with large battery packs will stand
upright but may be easily knocked over.
Avoid touching the tip of a drill bit just after drilling,
•
as it may be hot.
When fitting and changing accessories, always use
•
the instructions supplied with the accessory.
• Should your tool develop a fault, do not try to fix it
yourself, but take it to one of our authorized repair
agents.
Symbols
The label on your tool may include the following symbols:
V volts
A Amperes
Hz Hertz
W Watts
min. Minutes
Alternating current
Direct current
no No load speed
Class II Construction
Earthing terminal
Safety alert symbol
.../min Revolutions or reciprocation per minute
.../bpm Beats per minute
Using an Extension Cable
An extension cable should not be used unless absolutely
necessary. Use of an improper extension cable could
result in a risk of fire and electric shock. If an extension
cable must be used, use only those that are approved by
the country's Electrical Authority. Make sure that
extension cord is in good condition before using. Always
use the cord that is suitable for the power input of your
tool (see technical dataon name plate). The minimum
conductor size is 1mm ; the maximum length is 30m.
2
When using a cable reel, always unwind the cable
completely.
Features (Fig. A)
a. Variable speed switch
b. Forward/reverse slider
c. Keyless chuck
d. Mode selector/torque adjustment collar
e. Collar settings
f. Two gear selector
h. Grip
i. Battery pack
j. Release buttons
k. Charger
l. Charging indicator

Assembly and Adjustment

WARNING: Prior to assembly and adjustment,
always remove the battery pack. Always switch off the
tool before inserting or removing the battery pack.
WARNING: Use only Black &Decker battery packs
and chargers.
Inserting and Removing the Battery
Pack from the Tool (fi g. 2)
WARNING: To reduce the risk of serious
personal injury, turn tool off and disconnect
battery pack making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
TO INSTALL THE BATTERY PACK INTO THE TOOL
HANDLE
1. Align the base of the tool with the notch inside the
tool's handle (fig. 2).
2. Slide the battery pack firmly into the handle until you
hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release buttons (j) and firmly pull the battery
pack out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
INSERTING AND REMOVING BITS (FIG. 1, 4)
1. Open the chuck by turning the sleeve (p) counter-
clockwise and insert the bit shank.
2. Place the bit in the chuck as far as it will go and lift
slightly before tightening.
3. Tighten firmly by turning the sleeve clockwise.
ENGLISH
5