Operating Instructions - Kohler riverbath K-1397 Owner's Manual

5. OPERATING INSTRUCTIONS

NOTE: Exercise caution if you walk or move around in
the whirlpool, particularly if the unit is running. Acrylic
surfaces are inherently slippery when wet.
NOTE: The River Jets will only operate if both
water-level sensors are completely covered with
water. If the water level drops below the sensors while
the River Jets are running, they will automatically turn
off, and the eight Whirlpool Flexjets will start to run.
NOTE: The River Jets and Whirlpool Flexjets will not
operate at the same time. The Waterfall, however, will
run in conjunction with either the River Jets or the
Whirlpool Flexjets.
To use the Waterfall: press the "Waterfall" control
button once. The Waterfall will start to flow at
maximum volume within several seconds.
Adjust the water flow volume by pressing and holding
down the volume control arrows (YB) in the direction
desired.
Press the "Waterfall" control button a second time to
turn off the Waterfall.
To use the jets: press the "River" control button once
to start the jet functions. The eight Whirlpool Flexjets
will start to immediately flow at maximum volume
(Whirlpool mode). Adjust the water flow volume by
pressing and holding down the volume control arrows
(YB) in the direction desired.
Your Whirlpool Flexjet system adds air to the water
stream to increase the force of the water flow.
Decrease the force of the water flow by turning the
Whirlpool Flexjet trim rings clockwise until you obtain
the desired water force. Turn the trim rings
counterclockwise to increase the water flow force.
Press the "Whitewater – Rapids – Whirlpool" control
button once to turn off the Whirlpool Flexjets and turn
on all four River Jets (Whitewater mode). Water will
start to flow from the River Jets within several
seconds.
Press the "Whitewater – Rapids – Whirlpool" control
button a second time to turn off the two center River
Jets. The two outermost River Jets will continue to run
(Rapids mode).
Press the control button a third time to turn off all the
River Jets and restart the Whirlpool Flexjets in the
Whirlpool mode.
Press the "River" control button a second time to turn
off all the jet functions.
NOTE: A built-in timer automatically stops the pumps
and motors after approximately 20 minutes of
operation.
BD
117198-5-
"Waterfall"
Volume
Control
Control
Button
Arrows
"River"
Volume
Control
Control
Button
Arrows
Decrease the
Water Force
6 6
"Whitewater
Rapids
Whirlpool"
Control
Button
Increase the
Water Force
Kohler Co., Kohler WI U.S.A.