Makita HM1213C Technical Information page 14

R
epair
[3] ASSEMBLY/ DISASSEMBLY
[3]-7. Vibration Absorbing Handle (only for HM1213C)
DISASSEMBLING
(1) Disassemble Handle section. (the left illustration in Fig. 2)
(2) Vibration absorbing handle can be disassembled as illustrated in Figs. 31 and 32.
Fig. 31
Remove Compression spring 11 after separating
Handle section from the machine.
Compression Spring 11
Remove two 5x25 Tapping screws to disassemble
Handle in the next step.
ASSEMBLING
Assemble the Vibration absorbing handle, paying attention to the directions of Dust cover and Dust cover support. (Fig. 33)
Fig. 33
Flat washer 5
5x30 Tapping
screw (2pcs.)
Handle base
5x25 Tapping screw (2pcs.)
Shoulder
sleeve 6
Upper side
Dust cover
Fig. 32
5x30 Tapping screw
(2pcs.)
Remove two 5x30 Tapping screws.
The several parts are separated from
Handle base as illustrated above.
Handle cover can be removed
As the left Illustration in Fig. 26.
Dust cover support
Facing Triangle mark to the
upper side, insert Dust cover
support into Dust cover.
Facing the bow portion of Dust cover
to the upper side of the machine,
Assemble Dust cover to Handle.
Handle
Lower side
Flat washer 5
Dust cover support
Dust cover
P 14/ 17
Handle