LG 55LF5950 Service Manual page 12

▪ Standard color coordinate and temperature using
CA-210(CH-14) – by aging time
(2) Normal line (From March to December) : LGD
Aging time
X
(Min)
271
1 0-2 282
2 3-5 281
3 6-9 279
4 10-19 277
5 20-35 275
6 36-49 274
7 50-79 273
8 80-119 272
9 Over 120 271
▪ O/S Module (AUO, INX, Sharp, CSOT, BOE)
cool
x y
spec 271 270
target 278 280
5.2. Tool Option setting & Inspection per
countries
5.2.1. Overview
(1) Tool option selection is only done for models in Non-USA
North America due to rating
(2) Applied model: LA46H Chassis applied to CANADA and
MEXICO
5.2.2. Country Group selection
(1) Press ADJ key on the Adj. R/C, and then select Country
Group Menu
(2) Depending on destination, select US, then on the lower
Country option, select US, CA, MX.
Selection is done using +, - KEY
5.2.3. Tool Option inspection
▪ Press Adj. key on the Adj. R/C, then select Tool option
※ Tool option can be reconstructed by Software
5.2.4. Area Option
Area Area Option
USA 22282
CANADA 22411
MEXICO 22540
Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
Cool Medium Warm
Y X Y X
270 286 289 313
289 297 308 324
287 296 306 323
284 294 303 321
280 292 299 319
277 290 296 317
274 289 293 316
272 288 291 315
271 287 290 314
270 286 289 313
med warm
x y x
286 289 313
293 299 320
5.3. Magic Motion remote controller Check
5.3.1. Test equipment
▪ RF-remote controller for check, IR-KEY-CODE remote
controller.
▪ Check AA battery before test. A recommendation is that a
Y
tester change battery every lots.
329
5.3.2. Test
348
(1) Make pairing with TV set by pressing "Start key(Wheel
346
key)" on RCU.
343
(2) Check a cursor on screen by pressing 'Wheel key" of RCU
339
(3) Stop paring with TV set by pressing "Back+ Home" key of
RCU
336
333
5.3.3. Applied models
331
Chassis
330
LA50H Bluetooth Spec out
329
※ Dongle Model : An USB dongle-type receiver will be
y
329
5.4. Wi-Fi MAC Address Check
339
5.4.1. Using RS232 Command
Transmission
5.4.2. Check the menu on in-start
5.5. HDMI ARC Function Inspection
5.5.1. Test equipment
- Optic Receiver Speaker
- MSHG-600 (SW: 1220 ↑)
- HDMI Cable (for 1.4 version)
5.5.2. Test method
(1) Insert the HDMI Cable to the HDMI ARC port from the
master equipment (HDMI1)
(2) Check the sound from the TV Set
(3) Check the Sound from the Speaker or using AV & Optic
TEST program (It's connected to MSHG-600)
- 12 -
Remark
supplied in form of accessory. So this
pairing test is not necessary for these
models
Command Set ACK
[A][l][][Set ID][][20][Cr] [O][K][x] or [N][G]
LGE Internal Use Only