Zanussi ZRB36104WA User Manual page 26

Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.
26
Possible cause
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
Solution
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
www.zanussi.com