Setting The Oven Controls; Setting The Clock - Kenmore 790.4500series Use & Care Manual

Setting Oven Controls

Setting the Clock

The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press . «CLO» will appear in the display (Figure 2).
1 3 0
2. Press
(Figure 3). «CLO» will stay in the display. Press
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold
display. After 3 seconds
that the cooktop lockout is active (Figure 5). CONTINUE holding
the pad until «12h» (Figure 6) or «24h» (Figure 7) appears in
the display and the control beeps once.
Flex
2. Press Clean to switch between the 12 and 24 hour time of day
display. The display will show either «12h» (Figure 6) or «24h»
(Figure 7).
START
3. Press to accept the change or press
change. will disappear from the display.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
pads to set the time of day to 1:30
for 7 seconds. «CLO» will appear in the
will appear in the display indicating
STOP
PRESS
1
START
. «CLO»
for 7 seconds
to reject the
START
15
TIMED DELAY TIMER
DOOR LOCKED CLEAN
Figure 1
DISPLAY
TIMED DELAY TIMER
DOOR LOCKED CLEAN
3 0
Figure 2
START
TIMED DELAY TIMER
DOOR LOCKED CLEAN
Figure 3
TIMED DELAY TIMER
DOOR LOCKED CLEAN
Figure 4
Flex
Clean
TIMED DELAY TIMER
DOOR LOCKED CLEAN
Figure 5
STOP
or
Figure 6
Figure 7
CONV BAKE BROIL
ROAST WARM PROBE
CONV BAKE BROIL
ROAST WARM PROBE
CONV BAKE BROIL
ROAST WARM PROBE
CONV BAKE BROIL
ROAST WARM PROBE
CONV BAKE BROIL
ROAST WARM PROBE