How To Change An Option Byte - Philips 27PS60S321 Technical Service Data

4. GEOMETRY
5. AUDIO
Options
Figure: Options Menu
Options are used to control the presence or absence of certain features and hardware.

How to change an Option Byte

An Option Byte represents a number of different options. Changing these bytes directly
makes it possible to set all options very quickly. All options are controlled via seven
option bytes.
To change Option Byte(s):
1. Enter SDAM:
Press the following key sequence on the remote control transmitter:
0-6-2-5-9-6-MENU
Do not allow the display to time out between entries while keying the sequence.
2. Use the MENU UP/DOWN keys to highlight the OPTIONS sub menu.
3. Press the MENU LEFT or MENU RIGHT key to enter the OPTIONS sub menu.
4. In the OPTIONS sub menu, press the MENU UP/DOWN keys to select OP 1
through OP 7.
5. Use the number keys on the remote control transmitter to enter a new value for
the selected option byte. The value must be entered as a three-digit value (for
example, "4" would be entered as "0-0-4").
6. The selected value must be between 0 and 255.
7. When all desired changes to the option bytes are made, press the MENU button
to return to the top level SDAM menu. This will save changes to the option byte
settings.
8. To ensure the option byte changes take effect: Turn the television set OFF by
using the POWER button on the remote control transmitter or the local
keyboard. Disconnect the television set from AC power for at least ten seconds.
Reconnect the television set to AC power. Turn the television set ON by using
the POWER button on the remote control transmitter or the local keyboard.