Basic Antenna Connection - Philips 25PS40S99 Directions For Use Manual

H
OOKING
A
combination antenna receives
normal broadcast channels
(VHF 2-13 and UHF 14-69). Your
connection is easy since there is
only one 75Ω (ohm) antenna plug
on the back of your TV - and that's
where the antenna goes.
If your antenna has a round cable
(75 ohm) on the end, then you're ready
to connect it to the TV.
If your antenna has flat twin-lead wire
(300 ohm), you first need to attach the
antenna wires to the screws on a 300 to
75 ohm adapter.
Push the round end of the adapter
(or antenna) onto the 75Ω plug on the
rear of the TV. If the round end of the
antenna wire is threaded, screw it down
finger tight.
S H
MART ELP
Remember: Be sure to set the
TV for the type signal you've
connected (see the "Tuner Mode" sec-
tion on page 11 of this manual.)
To set the TV to select only the channel
numbers in your area see how to
"Program" or "Add" channels in the
TV's memory on page 12 (Auto
Program section).
To order any optional accessory contact
your dealer or the Philips Parts Center
at 1-800-851-8885.
Combination VHF/UHF
Antenna
(Outdoor or Indoor)
U Y TV (B
P OUR
1
Twin Lead
Wire
Round Cable
75Ω
A
ASIC NTENNA
Note: For homes with separate UHF and VHF antennas
you will need an optional combiner to connect to the TV.
U/V
Combiner
75-300 Ohm Adapter
300 to 75Ω
Adapter
75
OR
6
TV C
ONNECTIONS
Back of TV
75
2
Back of TV
)