Basic Cable Tv Connection - Philips 25PS40S99 Directions For Use Manual

H U
OOKING
Y
our Cable TV input into your
home may be a single (75 ohm)
cable, or a Converter Box installa-
tion. In either case the connection to
the TV is very easy. Just put the
threaded end of the cable signal to
the TV's antenna plug and screw it
down finger tight.
If your Cable TV signal is a single
round cable (75 ohm) then you're
ready to connect to the TV.
If you have a Cable Converter Box:
Connect the Cable TV signal to the
Cable Signal IN(put) plug on the
Converter.
Connect the Cable TV cable to the
75Ω plug on the TV.
If you have a Cable Converter Box:
Connect the OUT(put) plug from the
Converter to the 75Ω plug on the TV.
S H
MART ELP
Remember: Set the TV for the
type signal you've just connected
(see the "Tuner Mode" section on page
11 of this manual.)
To select only the channel numbers on
your Cable system see "Auto Program"
(page 12). If you use a Cable Converter
box, set the TV to the same channel as
the converter's CH 3/4 switch (on the rear
of the converter.)
Y TV (B
P OUR
Cable TV Company
Cable TV Converter
Box Connection
C TV C
ASIC ABLE
Cable TV Signal Input
OR
Round Cable
75Ω Ohm
5
)
ONNECTIONS
75
2
75
1
Back of TV