Camera link output settings
Camera link tap can be selected from 1, 2, 3, 4, 8, or 10.
Pixel clock frequency can be selected from 45 MHz, 65 MHz, or 85 MHz.
By turning down the clock frequency, the length of the camera link cable can be extended because of durability
improvement against the attenuation of image signals.
Camera link tap and Pixel lock settings will be saved on the flash memory automatically and enabled after restart.
You don't have to set each time when launching the application.
Command
CAMERALINK-TAP
BASE-CLOCK
Combinations of camera link taps and output bit lengths.
When the camera link tap is set at 8 or 10, the image signal output level is 4 times as high as when set as 1, 2, 3, or 4.
Output Bit Length
z Usable function – Not usable function
* To output in 16-bit length, enable wide dynamic range (see page 39).
When wide dynamic range is not enabled, only the top 12-bit will be enabled.
Camera link configuration settings
CAMERALINK-TAP
1
2
3
4
8
10
Parameter
1/2/3/4/8/10
Setting other than provided in left will not work.
45/65/85
Specify clock frequency [MHz].
Setting other than provided in left will not work.
1
8
z
z
10
z
12
z*
16
Configuration
Base
Base
Base
Medium
Full
80bit
CAMERALINK-TAP
2
3
z
z
z
–
z
–
–
–
12
4
8
z
z
z
–
z
–
–
–
10
z
–
–
–