Open Scan (Os) Mode - Uniden UH9000 Owner's Manual

Operation
4. Turn the rotary knob or press
DCS code 01 - 104
CTCSS:
5. Press to store the setting.
6. Press and hold

Open Scan (OS) Mode

All UHF-CB, user-programmed extra RX channels, Police and Fire & Ambulance
frequencies have been added to the OS SCAN Memory for convenience. To add/remove
channels from OS SCAN Memory, refer to page 23.
Allows continuous scanning of all selected channels. If an active channel is found, scanning
will stop on that channel. If the received signal ceases, the unit will wait 2 seconds for the
signal to return, otherwise scanning resumes.
After transmission in scan mode, the unit will wait 20 seconds for the signal to return,
otherwise scanning resumes.
To select OS Scan Mode:
1. Press 9 times. The SCAN setting flashes.
2. Turn the rotary knob or press
press to save scan type setting.
3. Press and hold
UNIDEN UH9000
/
to save & exit the menu mode.
/ on the microphone till OPEN flashes and
to save and exit from the Menu mode.
to select desired CTCSS code 01 - 38 or
DCS:
25
UHF CB Transceiver