9.1.7.
BD Drive
1. Remove the OPU FFC, and isolate it with an ESD pre-
vention bag (RPFC0114) to prevent the laser diode from
the ESD damage. (PX/PU only)
2. Remove the 3 FFCs.
3. Remove the 4 Screws (A ) to remove BD Drive.
9.1.8.
Digital P.C.B.
1. Remove the connector.
2. Remove the 2 Screws (A).
9.1.9.
Power SW P.C.B. & SD P.C.B.
1. Remove the 3 Screws (A).
9.2.
BD Drive
9.2.1.
Tray
1. Insert the Paper clips, etc. into the hole of the bottom
side, and slide it to the direction of arrow until it can be.
2. Pull the Tray to the direction of arrow until it can be.
3. Push the two posts in front of the mecha chassis to both
sides of the drive to unlock the tray, and push it outward
simultaneously.
33