Resetting The Side Windows - Mercedes-Benz GLC Operator's Manual

Side windows
92
Vehicles with KEYLESS-GO or KEYLESS-GO
start function: if the SmartKey is in close prox-
imity to the vehicle, the convenience closing
function is available.
When you lock the vehicle, you can simultane-
ously:
close the side windows
R
close the panorama roof with power tilt/slid-
R
ing panel
On vehicles with a panorama roof with power
tilt/sliding panel, you can then close the roller
sunblinds.
Notes on the automatic reversing feature for:
the side window (
R
the panorama roof with power tilt/sliding
R
panel ( page 94)
Y
Using the SmartKey
Press and hold the & button until the side
X
windows and the panorama roof with power
tilt/sliding panel are fully closed.
Make sure that all the side windows and the
X
panorama roof with power tilt/sliding panel
are closed.
Press and hold the & button again until the
X
roller sunblinds of the panorama roof with
power tilt/sliding panel are closed.
To interrupt convenience closing: release
X
the & button.
Using KEYLESS-GO
The driver's door and the door at which the han-
dle is used, must both be closed. The SmartKey
must be outside the vehicle. The gap between
the SmartKey and the corresponding door han-
dle should not be greater than 3 ft (1 m).
page 90)
Y
Touch recessed sensor surface : on the
X
door handle until the side windows and the
panorama roof with power tilt/sliding panel
are fully closed.
Make sure you touch only recessed sensor
surface :.
Make sure that all the side windows and the
X
panorama roof with power tilt/sliding panel
are closed.
Touch recessed sensor surface : on the
X
door handle again until the roller sunblinds of
the panorama roof with power tilt/sliding
panel close.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.

Resetting the side windows

If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is com-
page 90).
pletely closed (
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above.
page 90).